Using Sound Boards And Audio Cables - Plextor PX-712 Installation And User Manual

Section 2. Installing the PX-712A Internal ATAPI Drive
11. Connect a digital audio cable if your sound board is equipped with
the Sony/Philips Digital Interface (SPDIF) or Digital-In, and you
wish to use the digital audio output from your PX-712A. This cable
runs from the digital audio output connector pins on the PX-712A
back panel to the sound board. (This cable is not supplied by
Plextor.)
12. Mount the PX-712A drive in the computer using the four screws that
were supplied with your drive. Use only these screws.
CAUTION: Do not mount your drive in your computer using screws other
than those supplied by Plextor. You may damage the drive if you insert
screws that are too long or the wrong thread type.

Using Sound Boards and Audio Cables

Whichever category your sound board falls into, you will find that the
best source of information about installing the sound board in your
computer is the board's manual. Once you have successfully installed the
sound board in your computer, you can continue below for a description
of the different cable connections that need to be made.
If you need audio cables, you will have to purchase them. Refer to the
table below. A list of several vendors who offer audio cables is available
on Plextor's web site.
32
PX-712 Installation and Users Manual