Plextor PX-712 Installation And User Manual page 115

Rear Panel, PX-712A Internal ATAPI Drive (continued)
Power Average 17.4W for DVD read/write
Consumption
IDE Interface IDE bus, 40-pin flat ribbon type. Interface complies
Connector with ATA/ATAPI-5. Maximum total cable length
cannot exceed 18 in (45.7 cm).
Analog Audio Stereo analog output, Molex connector (L*G*G*R),
Output MPC-3 standard:
Output voltage (max. volume): 0.55V(rms) ±1V
Load impedance: 10 k ohms
S/N ratio: Min. 80dB
Total harmonic distortion+noise: Max. 0.08%
(1kHz)
Dynamic range: Typically 75dB (1kHz)
Channel separation: Typically 70dB (1kHz)
Frequency response: 20Hz to 20kHz (0dB ±5dB)
Digital Audio Digital audio output for input to SPDIF or Digital-In
Output input
Mode Jumper Master (default), slave, cable select (CSEL)
DMA Jumper Open (no jumper): Ultra DMA mode 0-2 (default)
Short (jumper installed): Multiword DMA mode 0-2
Dimensions and Weight, PX-712A Internal ATAPI Drive
Dimensions 5.75" x 1.63" x 7.48"
(W/H/D) 146 mm x 41.3 mm x 190 mm
(excluding
front panel)
Weight < 2.2 lbs. (1.0 kg)
Appendix A: PX-712 Specifications
PX-712 Installation and Users Manual
105