Dimplex XHD23L Service Manual page 4

Icon Function
A Power
B Heat
C Temperature
Disable Heat
C /
o
Temp
D Flame Speed
Color
E
Themes
4
Press to turn unit Off or On.
• Unit Off
Press to turn everything Off. Press again to turn unit On with previous settings.
• Unit On
Press to turn unit On with previous settings.
- If the flame effect was On, the flame will turn on and the previous heat setting
will be activated (On or Off). Display will show current heater temperature
setting and after 2 sec displays the room temperature.
- [remote only] If the flame effect was Off, the previous heat setting will be
activated (On or Off).
- [panel only] If the flame effect was Off, the flame will turn on and the previous
heat setting will be activated (On or Off)
• Heat On
Press to turn heat On (indicated by 1 short beep). Display will show current
heater temperature setting and after 2 sec displays room temperature. Use the
Temp icon to change the heater temperature setting.
• Heat Off
Press to turn heat Off (indicated by 1 short beep).
NOTE: After the heater is switched off, the fan will continue on for 60 seconds before turning
off.
Press multiple times to raise the heater temperature in 1
Display will show current temperature. Temperature range is 62
This feature is active whenever the heat is enabled.
Using the manual controls, press the Heat and Temp buttons at the same time
and hold for 2 second to disable the heater. Press and hold again for 2 seconds to
enable the heater.
When the heater is disabled, "--" will display when Temp button is pressed. The
remainder of the unit's controls will operate in the same fashion.
F The display can show the temperature reading in either
o
display, press and hold the Temp and Flame Speeds buttons on the unit.
Press multiple times to toggle through flame speeds (minimum, medium,
maximum). Display will show current speed number (F1, F2, F3 respectively).
Press multiple times to change the media and flame base colors. This feature is
active only when the flame effect is On. Display will show theme (t0, t1, t2, etc.)
XHD28L, XHD26L or XHD23L (Log Unit) themes:
• Theme t0 - no flame
• Theme t1 - Natural (flame base off)
• Theme t2 - Red Highlights (flame base red/orange)
• Theme t3 - Blue Highlights (flame base blue)
XHD28G, XHD26G or XHD23G (Media Unit) themes:
• Theme t0 - Midnight Mode
• Theme t1 - Media White
• Theme t2 - Media red/orange flickering
• Theme t3 - Media blue flickering.
• Theme t4 - Media Purple
• Theme t5 - Media Green
• Theme to - Prism Mode (To choose a custom color, press Brightness icon. Press
again to return to Prism Mode)
Description
F (1
o
C or
o
C) increments.
o
-78 F (17 -26 C).
o o o o
F. To change the
o
www.dimplex.com