Table of Contents
Advertisement
1. Frame
1a. Carrying handle
2. Carrying strap
3. Curved pipe
4. Hose clip
5. Flexible pipe (D)
6. Hose clip
7. Control pipe (C)
8. Operating lever
9. Throttle
9a. Throttle lock
10. On/Off switch
11. Pipe extension (B)
11a. Pipe extension (B)
12. End pipe, round (Al)
13. Attachment hole (for the
carrying strap)
3. ASSEMBLY
(See fig. A)
1) Take the two hose clips (4) + (6) and slide them over the ends of the flexible pipe (5).
2) Push the larger end of the flexible pipe (5) onto the curved pipe (3) and tighten the hose
clip (4) using the flat-head screwdriver (26) .
3) Slide the control pipe (7) into the flexible pipe section (5) and tighten the hose clip (6) using
the flat-head screwdriver (26).
4) First loosen the fixing screws (22) on the operating lever (8).
5) Slide the operating lever (8) onto the guide of the head pipe (7).
6) Attach the operating lever (8) using the supplied fastening screws (22) and locking nuts
(23) .
7) Push the pipe extension (11) onto the control pipe (7).
8) To fix the pipe extension (11a) in place, turn it clockwise (see fig. A) and secure it by
tightening the inserted screw.
9) If an extension is required, push the second pipe extension (11a) onto the previously
mounted pipe extension (11).
10) To fix the pipe extension (11a) in place, turn it clockwise (see fig. A) and secure it by
tightening the inserted screw.
11) Push the desired end pipe (round) (12) or end pipe (flat)(24) onto the pipe extension(11) or
(11a) and fix it in place by turning it clockwise (see Fig. A) and secure it by tightening the
inserted screw
14. Spark plug connector
15. Choke
16. Pull start
17. Fuel tank cap
18. Fuel tank
19. Locking screw )for the air
filter cover)
20. Air filter cover
21. Fuel pump (primer)
22.
1x
fastening screws (for
the operating lever)
23.
1x
locking nuts (for the
operating lever)
24. End pipe, flat (A2)
25. Mixing tank
26. Spark plug wrench/flat-
head screwdriver
8
Advertisement
Table of Contents
