Table of Contents
Advertisement
risks associated with inhaling harmful dust.
-
Before starting the machine, clear the area where you are going to use it. Remove stones,
broken glass, nails, wire ropes, ropes or other objects that could be thrown or get caught in
the machine.
-
Always keep a good balance. Support yourself well on your legs and do not extend your
arm too far. Otherwise, you could fall, slip or injure yourself.
-
Let your machine cool down before putting it away.
-
Before transporting this machine in a vehicle, empty the fuel tank and secure the machine
so that it cannot move during transport.
-
To reduce the risk of fire and burns, handle fuel with care. It is an extremely flammable
substance.
-
Do not smoke when handling fuel.
-
Mix and store fuel in a container designed to hold gasoline.
-
Mix the fuel in the open air, away from any sparks or flames.
-
Choose a clean, bare surface, stop the engine, and allow it to cool before filling it.
-
Slowly unscrew the fuel cap to relieve pressure and prevent fuel from spilling around the
cap.
-
Screw on the tank cap firmly after filling.
-
Wipe down the machine if you have spilled fuel.
-
Move at least 10m away from where you filled the fuel tank before starting the engine.
-
Never attempt to burn spilled fuel.
-
When replacing, use only replacement parts and accessories recommended by the
manufacturer. Failure to do so could reduce the efficiency of your machine and put you at
risk of injury.
-
Maintain your machine with care, according to the instructions in the "Care & Cleaning"
section of this manual.
-
Check the condition of your machine before each use. Make sure that the fasteners are
tight, that there are no fuel leaks and that no parts are damaged. Replace any damaged
part.
-
To reduce the risk of injury from contact with moving parts, stop the engine before installing
or removing accessories.
-
Do not use your machine if the protective elements are not installed. Always remove the
spark plug before carrying out any maintenance or working on any moving part.
-
Do not point the blower nozzle at people or pets.
-
Never start this machine if the required accessories are not installed.
-
Do not operate the machine near open windows,
-
Use a rake and broom to loosen debris before blowing.
-
Lightly dampen surfaces in dusty conditions before working.
-
Use the pipes fully assembled so that the air flow can reach the floor.
-
Caution: there is a risk of danger from rotating parts. Avoid coming into contact with them.
-
In case of blockage or breakdown, stop using the machine immediately. Inspect it and
remove the blockage securely (see chapter "Maintenance). In the event of a fault, please
take your machine to a qualified service for inspection.
Maintenance and storage
When the machine is stopped for servicing, inspection, or storage, or to change an accessory,
shut off the power source and make sure that all moving parts have come to a complete stop.
Allow the machine to cool before making any inspections, adjustments, etc. Maintain the
machine with care and keep it clean.
-
Store the machine in a dry place out of the reach of children.
-
Always allow the machine to cool before storing.
-
Replace worn or damaged parts for safety. Use only genuine replacement parts and
accessories.
4
Advertisement
Table of Contents
