Installing The Wall Brackets - PRx Performance Profile PRO Installation Instructions Manual

Installing the Wall Brackets

1. Begin by determining if your floor slopes down to the left, down to the right, or is flat. See Figure 2. If
it slopes down to the left, start with the far-left stud. If it slopes down to the right, start with the far-right
stud.
2. Locate two studs spaced 48" apart in the wall using a stud finder (Figure 2).
3. Mark the first hole 21" from the floor and a second hole 90" from the floor centered on the far-left stud
(or right depending on your floor slope).
4. Measure down 4" from each mark from step 3 to mark the third and fourth holes.
5. Use the cordless drill and the 7/32" drill bit to drill the four marked holes at least 2-1/2" deep.
Figure 2: Hole Drill Locations
4