Enable User; Set Time Delay - Securam ScanLogic Audit Operating Instructions Manual

Both the code and fingerprint enrolled as ID03 are now disabled.
Note: Administrators cannot be disabled.
11. Enable User (Level 3)
This programming step is necessary to enable a User's access rights - both fingerprint and
code. This step would be performed after a User has been "Disabled" – See #9 Disable User.

Unlock the system with an administrator's fingerprint (ID No. 01 or 02).

The LCD will display "Select Menu"

Press "▲" or "▼" to scroll to
Press "Menu/OK".
Press "▲" or "▼" to select the ID No. to enable (e.g. ID 03).
Press "Menu/OK".
Now the No. 03 user is enabled.
12. Set time delay (Level 3)
Time Delay is security protocol used to deter burglary. Provided the prospective burglar has
knowledge that a Time delay safe is in use, the likelihood of burglary is greatly reduced.
Time Delay is a feature that requires the User present an enrolled fingerprint or enter a valid
code, wait a prescribed period of time, and then present an enrolled fingerprint or enter a valid
user code again to gain access.

Unlock the system with an administrator's fingerprint (ID No. 01 or 02).

The LCD will display "Select Menu"

Press "▲" or "▼" to scroll to
Press "Menu/OK".
Press "▲" or "▼" to set time delay (00 to 99 min).
Press "Menu/OK".
SECURAM Systems Inc.

"Enable User".

"Set/Cancel Time Delay".
Page 8