Set/Change User Code; Enable And Set User Code - Securam ScanLogic Audit Operating Instructions Manual

7. Set/Change User Code (Level 3)

Unlock the safe lock system with an administrator's fingerprint (ID No. 01 or 02).

After successful verification, the screen will show "Select Menu".

Press "▲" or "▼"

Press "Menu/Ok".
Enter a code (10 digits).
Enter the same code again.

Now the new code is set or changed successfully.
Note:
● Administrators' code can be set or changed using the method described above.
Non-administrators' codes (ID03-ID30) must be enabled by the administrator first, then,
the user can set or change their own code.
8. Enable and Set User Code (Level 3)
This programming step is necessary to allow a User to have code access in addition to
fingerprint access.

Unlock the system with an administrator's fingerprint (ID No. 01 or 02).

The LCD will display "Select Menu"

Press "▲" or "▼" to scroll to "Enable User code", press "Menu/Ok".
Press "▲" or "▼" to select the ID No. to be enabled.
Press "Menu/Ok"

In the example, the User ID No.3 code is enabled and is ready to be programmed.
To Program or "Set" the User Code:

Unlock the safe lock system with the fingerprint of ID No.03.

The LCD will display "Select Menu"

Press "▲" or "▼" to scroll to "Set/Change User Code".
SECURAM Systems Inc.
to scroll to

"Set/Change User Code"

Page 6