10 | Installing the Board and Display
Installing multiple boards
Repeat the installation instructions on page 8 for each board.
Remember these tips when you are installing multiple boards:
• You can install as many RX/PCI boards as your system's
• The Windows NT driver supports up to eight boards
• Each board requires less than 5 amps of +5V.
• For PCs, you must disable VGA mode on all but one RX/PCI
• In Sun workstations, you can install different boards in the
power supply and available PCI slots can support
(Windows 2000, Windows XP, and Solaris).
(16 screens) of the same type. You cannot mix DOME board
types, but you can mix single- and dual-headed boards.
board if multiple boards are in use. See "To disable VGA
mode" on page 6.
same system.