Table of Contents
Advertisement
The default settings for switch S1, located below switch S2,
are all OFF.
Supporting VGA for PCs
Determine which board will support VGA display:
• The RX/PCI board
• Another VGA board
To install more than one RX/PCI board, see "Installing
multiple boards" on page 10.
Disable VGA mode if the RX/PCI board is used with an existing
VGA board or with multiple RX/PCI boards. Enable VGA if the
RX/PCI board's VGA port is used.
To use the RX/PCI board as the VGA console
1
Remove the existing VGA board from your computer.
2
Enable VGA mode on the RX/PCI board by following the
instructions under "To enable VGA mode" on page 6.
3
Install the RX/PCI board by following the instructions
on page 8.
To support VGA with another board
You must disable VGA mode on the RX/PCI board.
See "To disable VGA mode" on page 6.
When you install the RX/PCI board in a computer with an
existing VGA board, only one board can support the Windows
operating system. You can run Windows on either board, but
you cannot run Windows on both boards simultaneously.
Setting DIP Switches on the Board | 5
Advertisement
Table of Contents
