Table of Contents
Advertisement
16 | Installing the Md5/PCX Board and Driver in a PC
Installing multiple boards
Repeat the installation instructions on page 13 for each board.
Remember these tips when you are installing multiple boards:
• The Windows NT driver (version 4.01–4.3.3) supports
up to four boards (eight screens) of the same type. You
cannot mix board types, but you can mix single- and
dual-headed boards.
• The Windows NT driver (version 4.4.0) supports up to
eight boards (16 screens) of the same type. You cannot
mix DOME board types, but you can mix single- and
dual-headed boards.
• Each board requires less than 5 amps of +5V.
• You can install as many Md5/PCX boards as your system's
power supply and available PCI slots can support.
• You cannot mix DOME board types; additional boards must
be Md5/PCX boards.
• You must disable VGA mode on all but one Md5/PCX board
if multiple boards are in use. See "To disable VGA mode" on
page 11.
Advertisement
Table of Contents
