Kubota ACHILLES A18 Owner's Handbook Manual page 78

4. Mount a new point on the adapter.
(1) Rubber plug
(2) Lock pin
(3) Point
(4) Tooth adapter
5. Align the holes of the point and adapter
and knock in the rubber plug together
with the lock pin until the top surface of
the pin is flush with the top surface of the
adapter. (It is recommended to replace
the rubber plug and lock pin when
replacing the point.)
 Replacing the Bucket
3
CAUTION
To avoid personal injury:
 The bucket can tilt over and
cause accidents if in an unstable
position.
Therefore:
1) Only change the bucket if
no other persons are in the
area.
2) Lower the bucket on an even
ground and make sure that it
will not tilt when touched.
69