Kubota ACHILLES A18 Owner's Handbook Manual page 34

Procedure
1. Press the work light switch or the
display selector switch on the meter
with the key OFF. (Keep the key at OFF.)
2. The message shown above appears.
3. Add fuel.
4. The buzzer sound interval changes
according to the amount fuel added. As
the fuel amount becomes close to full,
the buzzer sound changes to continuous
beeping.
3
CAUTION
To avoid personal injury:
 If the fuel is poured too fast, the
buzzer may not sound according
to the fueling process.
 The moment when the fuel
tank is nearly full, the buzzer
starts beeping.
 Look into the fuel tank when
pouring the fuel.
Listen to the buzzer sound for
a rough estimate of the fill-up
progress.
 Water Temperature Gauge
3
CAUTION
To avoid personal injury:
 Do not open the radiator cap
during or just after operation.
Hot water may gush out and
scald you. Wait for the water to
cool down before opening the
cap.
With the starter key at the "RUN" position,
the cooling water temperature is indicated.
If the water temperature indicator is near
"H", take the steps below.
1. Discontinue the job.
2. Reduce engine rpm's to idle and keep it
at idle for 5 minutes.
3. Stop the engine and check the following
points (1)-(3).
 Hour-meter
Indicates the total operating hours of the
machine.
How the indicator works
 The meter advances one
an hour of operation regardless of the
engine rpm.
 Engine tachometer
Indicates the current rpm of the engine.
NOTE:
 The LCD display may be illegible when
viewed from a certain angle. This is not a
display failure.
25
hour after