Pressing Dough - Proluxe DP2350S Operation Manual

Hydraulic automatic dough press
Table of Contents

Advertisement

2. Set the timer in accordance with the
following information:
● 2-4 seconds​ –For warm dough with
moderate yeast content.
● 2-6 seconds​ – For room temperature
dough with moderate yeast content.
● 6-8 seconds​ – For cold dough right
out of the refrigerator with low yeast
content.
4. ​ R esetting the Counter:
Press MODE button until the
counter is displayed.
To reset the counter (# of 
cycles), simultaneously push UP 
(↑) or DOWN (↓) arrow buttons 
(approx. 5 seconds). 
D O U G H P R E S S I N G 
 
O P E R A T I O N S
Pressing Dough: 
For best results, your dough should be 
proofed before pressing, but it will also press 
directly out of your refrigerator. Flour is not 
required to press a crust and ​ s hould NOT​ be 
dusted on any part of the machine.  
1. Check to see if you have the correct type
of electrical current or serious damage could
occur.
2. Press the power button, the green light
above will illuminate when powered on.
3. Set your desired temperature on the
control panel by using FIG. A and the
instructions above. We recommend a
temperature of 150ºF. Testing with your own
dough may desire a different setting.
Note ​ : Heat is provided in the upper and lower 
platens enable the dough to flow more rapidly in 
the pressing cycle. The heat IS NOT intended for 
baking ​ .  
4. Swing open the upper platen and apply a
quick spray of a good water based food
release on the platen.
5. Place your pre-portioned ball of dough in
the approximate center of the lower platen.
Add another spray to the top of the dough
ball.
6. Close the platen and, with both hands,
press the two green buttons on each side of
the machine simultaneously.
7. Hold the buttons in until it beeps then
release both buttons. The timer will actuate
and, when the time cycle is completed, the
platens will release automatically. (Timer is
factory preset for six (6) seconds.
Instructions to change the timer is found
above under Controller Operations.)
9. Remove the finished product by rotating
the upper platen until you have proper space
to remove your dough.
10. Remove the crust, place on a pan or peel,
add toppings and bake.
R E C O M M E N D E D S E A S O N I N G 
& C L E A N I N G P R O C E D U R E S 

Advertisement

Table of Contents
loading

This manual is also suitable for:

Apex pro x2

Table of Contents