Advertisement
SECTION 2 |
Installation
2.1 INSTALLATION GUIDELINES
The remote control is provided with 10M/33ft, Connecting Cable (See Section 1.2). Check the proposed routing distance
of the wire and use longer wire, if necessary.
•
Flush mounting of the Remote requires appropriate cut-out in the wall/panel (Dotted line in Fig 2.1) For this,
a paper template has been provided with the unit. Take necessary precautions to ensure any wiring/plumbing
running behind the wall/panel is not damaged.
•
Route the wire to ensure there are no kinks.
•
Use appropriate grommets when the wire is passed through holes in studs/partitions to prevent damage to
insulation.
2.1.2 TOOLS REQUIRED
Following tools are recommended:
• Phillips Head Screwdriver
• Knife/Saw
• Paper Template for cut-out (supplied with the unit)
Fig 2.1 EVO-RC Remote Cutout Dimensions for Wall/ Panel Mounting
2.2 FLUSH MOUNT INSTALLATION
To flush mount, the wall opening must have at least a 2" (5 cm) depth to make room for the remote and cable. Also,
the thickness of wall/panel board at the place of mounting should not be more than 13 mm to ensure that the RJ-45
jack opening is not obstructed (see Fig. 2.3).
11. Cut an opening in the wall using the supplied paper template (Based on Fig 2.1).
12. Drill four pilot holes (use 2.5mm diameter/#39 drill bit) for the 4 screws (3mm diameter, 16mm long) that will
attach the remote to wall (refer to Figure 2.1 for hole locations and dimensions).
13. Route one end of the cable through wall opening to the EVO
Remote Control Jack port on the EVO
• Level
• Pencil
Cut the wall / panel along the dotted
line with a jig saw.
This will create a pocket in the wall /
panel for ush mounting the EVO-RC.
102 mm / 4.02 in
Inverter/Charger.
™
• Hand Drill
• Drill Bit (2.5mm / #39)
122 mm / 4.80 in
132 mm / 5.18 in
Inverter/Charger, and then plug it into the RJ-45
™
Advertisement
