Advertisement
SECTION 4 |
4.1.2 Navigating Through Parameter Setup Menu Maps at Figs 4.1 & 4.2
a) Values or parameters shown are the default values for the 12V versions i.e. EVO-2212/3012.
b) For details of programmable ranges and default values of each of the parameters, please refer to Tables and
names of PARAMETER GROUP NOS. and Sections given below:
Parameter Group No.
1
2
3
4
5
6
7
8
c) Entering & navigating within Parameter Setup Menu Map (Figs 4.1 & 4.2) is explained below:
(i) Entering Parameter Setup Menu:
Press Enter Key from any of the Operating Mode Display Screens (Figs 3.2 to 3.6) to go to PARAMETER
•
GROUP NO.1 (CHARGE CURVE)
Screen for PARAMETER GROUP NO.1 named "CHARGE CURVE" will be displayed:
•
NOTE:
The 7 "PARAMETER GROUPS" in Figs 4.1 & 4.2 have the following 2 lines of display:
Line 1: Displays "SELECT PARAMETER"
Line 2: Displays the name of the PARAMETER GROUP (Names of the 7 PARAMETER GROUPS are
shown in Column 2 of Table under Section 4.1.2(b) above)
(ii) Navigating through "PARAMETER GROUP NOS." 1 to 7:
Press Up Key to scroll right to the next higher numbered "PARAMETER GROUP"
•
Press Down Key to scroll left to the previous lower numbered "PARAMETER GROUP"
•
Press Enter Key to select the desired PARAMETER GROUP NO. – PARAMETER SETUP SCREEN NO.1 of the
•
selected "PARAMETER GROUP NO." will be displayed
Press Back Key to go back to the previous Menu Level i.e. the Operating Mode Display Screen from where
•
Parameter Setup Menu was accessed (Figs 3.2 to 3.6)
(iii) Navigating through PARAMETER SETUP SCREENS under the selected "PARAMETER GROUP":
Press Up Key to scroll down to the next higher numbered PARAMETER SETUP SCREEN
•
Press Down Key to scroll up to the previous lower numbered PARAMETER SETUP SCREEN
•
Press Enter Key to select the desired PARAMETER SETUP SCREEN for changing parameter setting
•
Press Back Key to go back to previous menu level i.e. "PARAMETER GROUP" (displayed as"SELECT
•
GROUP")
4.2 PARAMETER SETUP PROCEDURE
4.2.1 General Information
Please refer to Fig 4.3 for general information on navigating the Parameter Setup Menu Maps at Fig 4.1 & 4.2.
Parameter Setup
Name of Parameter Group
CHARGE CURVE
INPUT SETTING
INPUT LOW LIMIT
INPUT HIGH LIMIT
OTHER FUNCTION
RC SETTING
TIME SETTING
STOP SD CARD
Table No.
4.1
4.4
4.5
4.6
4.7
-
-
-
Section No.
4.4
4.5
4.6
4.7
4.8
4.9
4.10
4.11
S E L E C T
G R O U P
C H A R G E
C U R V E
Advertisement
