Advertisement
10
Configuring Telnet
The following steps show how to access the Telnet configuration parameters and
change the password. The default password for initializing a Telnet session is
password (all lower-case). For security purposes, change the password to something
unique. For this example, replace the underlined word with a password of your
choosing. The NetVanta supports five Telnet sessions (0-4).
1. Verify that the prompt of your unit displays (config)#.
2. Enter line telnet 0 4 to change the configuration parameters for the Telnet session.
3. Enter password word to change the login password for the Telnet session.
4. Enter exit to return to the global configuration mode.
An enable security mode password must be defined before configured Telnet sessions are
activated. See the following step (Step 11) for information on password configuration.
11
Setting the Enable Security Mode Password
1. Verify that the prompt of your unit displays (config)#.
2. Enter enable password word to set the enable security mode password.
or
3. Enter enable password md5 word to encrypt the enable password using MD5
encryption.
The enable command security level passwords are case sensitive.
12
Saving the Configuration
1. Verify that the prompt of your unit displays (config)#.
2. Enter exit to leave configuration mode.
3. Enter copy running-config startup-config to save the current configuration to
memory. This command may be abbreviated as copy run start.
4. Enter exit to close the configuration session.
13
Completing the Installation
The NetVanta is now configured and operational. Complete the installation by connect-
ing the appropriate cables to the E1 and Ethernet networks. Please refer to the
NetVanta Hardware Installation Guide for more details on pinouts and cabling.
64200868L1-42A
Technical Support +1-256-963-8716
7
Advertisement
