Advertisement
1
Configuring the Unit
The NetVanta may be initially accessed and managed either via a console session or
through a Telnet session. See step 1a for console session instructions. Initiating a Tel-
net session requires using a hub and two Ethernet cables (one for the PC and one for
the unit). The default Ethernet IP address is 10.10.10.1. Refer to step 10 to change Tel-
net session settings.
1a
Initiating a Console Session
1. Connect a VT100 terminal (or PC with VT100 emulation software) to the NetVanta
CONSOLE port using a DB-9 (male) to DB-9 (female) straight-through serial cable.
2. Configure the COM port with the following parameters:
Data Rate: 9600
Data Bits: 8
Parity Bits: None
Stop Bits: 1
Flow Control: None
3. Open a VT100 terminal session. (Please refer to the appropriate VT100 terminal
software documentation for detailed instructions.)
4. Press the <Enter> key.
5. Enter enable at the > prompt.
6. Enter the password when prompted. The default password is password.
7. You are now at the # prompt. At the # prompt, enter config terminal to enter the
global configuration mode.
2
Technical Support +1-256-963-8716
64200868L1-42A
Advertisement
