Table of Contents
Advertisement
User's Guide
Error Messages
Paper Setup Auto Display is set to Off. Some
features such as paper size and type settings
may be unavailable. For details, see your
documentation.
Communication error. Check if the computer is
connected.
The combination of the IP address and the
subnet mask is invalid. See your documentation
for more details.
To use cloud services, update the root certificate
from the Epson Web Config utility.
Recovery Mode
*
In some print cycles a very small amount of surplus ink may be collected in the ink pad. To prevent ink leakage
from the pad, the product is designed to stop printing when the pad has reached its limit. Whether and how often
this is required will vary according to the number of pages you print using the borderless print option. The need
for replacement of the pad does not mean that your printer has ceased to operate in accordance with its
specifications. The printer will advise you when the pad requires replacing and this can only be performed by an
authorised Epson Service provider. The Epson warranty does not cover the cost of this replacement.
Related Information
"Supported Memory Card Specifications" on page 224
&
"Supported External Storage Device Specifications" on page 225
&
"Installing Applications" on page 186
&
"Application for Configuring Printer Operations (Web Config)" on page 172
&
"Updating Applications and Firmware" on page 186
&
Checking the Printer Status - Windows
1. Access the printer driver window.
2. Click EPSON Status Monitor 3 on the Maintenance tab.
Note:
❏ You can also check the printer status by double-clicking the printer icon on the taskbar. If the printer icon is not
added to the taskbar, click Monitoring Preferences on the Maintenance tab, and then select Register the shortcut
icon to the taskbar.
❏ If EPSON Status Monitor 3 is disabled, click Extended Settings on the Maintenance tab, and then select Enable
EPSON Status Monitor 3.
Solving Problems
Solutions
If Paper Configuration is disabled, you cannot use AirPrint. In addition,
messages notifying you that the paper size and type do not match are
not displayed. Keep this setting enabled unless you always use the same
size and type of paper and do not need to change the paper settings.
Connect the computer and the printer correctly. If you are connecting
over a network, see the page that describes the network connection
method from the computer.
If the error message is displayed during scanning, make sure that Epson
Scan 2 and Epson Event Manager are installed on the computer.
Enter the correct IP address or default gateway. Contact the person who
setup the network for assistance.
Run Web Config, and then update the root certificate.
The printer has started in recovery mode because the firmware update
failed. Follow the steps below to try to update the firmware again.
1. Connect the computer and the printer with a USB cable. (During
recovery mode, you cannot update the firmware over a network
connection.)
2. Visit your local Epson website for further instructions.
189
Advertisement
Table of Contents
