Operations; Selecting An Input Source - Pioneer PDP-505HD Operating Instructions Manual

O
PERATIONS

Selecting an input source

This section explains the basic operation of this unit.
Outlined on the following pages is how to turn the main
power on and off, put this unit in the operation or standby
mode and how to select connected components.
Before you begin, make sure you have:
÷ Made connections between this unit and AV
components or personal computer as described in the
section "Installation and Connections" starting on
page 9.
÷ Set up the on-screen menu to input signals from
components connected to INPUT3 and INPUT4 as
described in the section "Setting Up the System" on
page 17.
If no connections are made to these terminals,
on-screen setup is not necessary.
2,4
STANDBY/ON
2,4
INPUT
3
MENU
ADJUST
SET
S.MODE
RETURN
Operation panel of
the main unit
1
Switch MAIN POWER on the main unit to the on
position to turn the main power on.
The STANDBY/ON indicator lights red.
2
Press STANDBY/ON to put this unit in the
operation mode.
The STANDBY/ON indicator turns green.
20
<ARE1349> En
TV CBL DTV DVD
/VCR /SAT /LD
STANDBY/ON
INPUT
3
1 2 3 4
SCREEN
MODE AUTO STILL DISPLAY
POWER INPUT
RECEIVER DTV
VIEW
AUDIO C C CLEAR MODE
1 2 3
4 5 6
7 8 9
0 CH
¶
ENTER
CH
RETURN
CH VOL
MUTING
RECEIVER
EDIT/
TV/SAT/DTV/DVD
LEARN MENU
SOURCE SAT/DTV
%
POWER GUIDE
SET/
DVD SELECT
TOP MENU (SAT)/DTV
%
MENU INFO
FAVORITES
1 7 3 ¡
VCR REC
8 ¶ 4 ¢
Î
CU-PDP008
PLASMA DISPLAY REMOTE CONTROL UNIT
Remote control unit
3
Press INPUT on the remote control unit or the
main unit to select the input.
On the control panel of the main unit, input changes
each time INPUT is pressed as follows.
3 INPUT1
INPUT4 2
÷ Input cannot be changed when a menu screen is
displayed.
÷ When a signal from a personal computer is input, if
the signal is not compatible with this unit, "OUT OF
RANGE" will appear on the screen.
4
When viewing is finished, press
to put the unit in standby mode.
The STANDBY/ON indicator will blink and then remain
lit (red) indicating that the standby mode is engaged.
Operation is not possible while the STANDBY/ON
indicator is blinking (red).
5
Switch MAIN POWER on the main unit to the off
position to turn the main power off.
CAUTION
Please do not leave the same picture displayed on the screen for
a long time. Doing so may cause a phenomenon known as
"screen burn" which leaves a ghost, or residual, image of the
picture on the screen.
3 INPUT2
INPUT3 2
STANDBY/ON