Husqvarna DM 220 Operator's Manual page 15

a) If the front red light (B) comes on, tilt up the
product.
b) If the rear red light (C) comes on, tilt down the
product.
c) If the left red light (D) comes on, tilt the product
to the left.
d) If the right red light (E) comes on, tilt the product
to the right.
5. To stop the electronic level indicator temporarily,
push the ON/OFF button. If the ON/OFF button is
pushed again or the power is disconnected, the
electronic level indicator is set to drill in a horizontal
angle.
6. To stop the electronic level indicator, push and hold
the ON/OFF button for approximately 3 seconds.
To do a configuration of the electronic level
indicator
A configuration of the electronic level indicator can be
done to adapt to a specified drill angle.
1. Hold the product at a specified angle.
1794 - 001 - 24.03.2022
E
C
B D
2. Push the Reset button to set the specified drill angle.
This is now the new zero level for correctly aligned
drill angle.
3. To set the drill angle to drill in a horizontal angle,
push and hold the Reset button for 3 seconds. The
drill angle is also set to drill in a horizontal angle
when the product is disconnected from the mains
socket for a longer time.
To start the product
WARNING:
can rotate freely. The drill bit starts to rotate
when the motor starts.
WARNING:
started on the work day, do a check of the
PRCD. Refer to
1. Connect the power plug of the product to a power
outlet.
Make sure that the drill bit
The first time the product is
PRCD on page 9 .
15