Husqvarna DM 220 Operator's Manual page 11

12. When you do inverted drilling, make sure that you
comply to the applicable instructions. Refer to
prepare the product for inverted drilling on page 12 .
To use the product with a drill stand
CAUTION:
this section carefully.
CAUTION:
for the drill stand carefully.
• Always use a drill stand if you stand on a scaffold
when you drill.
• Make sure that the drill stand is correctly attached.
• Make sure that the product is correctly attached in
the drill stand. Refer to
operation with a drill stand on page 11 .
• Use only with approved Husqvarna drill stands.
Accessories on page 23 .
Refer to
• Attach the trigger lock bracket. Refer to
trigger lock bracket to the product on page 11 .
To prepare the product for operation with a
drill stand
1. Loosen the screw (A).
B
2. Remove the protective cover (B).
3. To attach the product to a drill stand, refer to the
manual for the drill stand. Use only with approved
Husqvarna drill stands. Refer to
page 23 .
To attach the trigger lock bracket to the
product
The trigger lock bracket must only be used when you
use a drill stand. The trigger lock bracket pushes and
holds the power switch to start position.
1. Attach the product to a drill stand. Refer to
prepare the product for operation with a drill stand
on page 11 .
1794 - 001 - 24.03.2022
To
If you use a drill stand, read
Read the operator's manual
To prepare the product for
To attach the
A
Accessories on
To
2. Turn the knob (A) clockwise.
A
3. Install the trigger lock bracket to the product.
4. Turn the knob (B) counterclockwise to push and hold
the power switch to start position.
B
To use the product handheld
1. Install a drill bit with a maximum diameter of 80 mm.
The larger the drill bit, the more dangerous reaction
if the drill stops to move freely.
2. Lock the auxiliary handle tightly in position before
you start to drill. Refer to
in an applicable position on page 12 .
3. During operation, keep a stable position with you
feet on the ground.
WARNING:
ladder. If the drill bit stops suddenly, the
strong torque can cause you to fall.
4. Change the gear to 2 or 3. Refer to
on page 14 .
WARNING:
drilling in first gear. The product has a
strong torque that can result in injury if
the drill bit stops to move freely.
To set the auxiliary handle
Do not drill from a
To change gear
Do not do handheld
11