Husqvarna DM 220 Operator's Manual page 12

To set the auxiliary handle in an
applicable position
1. Turn the handle counterclockwise to release it.
2. Move the handle around the spindle shaft to an
applicable operation position.
3. Turn the handle clockwise to lock it. Tighten fully.
To prepare the product for dry drilling
WARNING:
protection. Do not breathe the dangerous
dust.
WARNING:
vacuum cleaner. Use only dust extractors
made especially for dangerous dust.
Accessories on page 23 for
Refer to
specifications.
1. Attach the dust extractor (A) to dust extractor
connector (B).
B
2. Start the dust extractor.
12
Use approved respiratory
Do not use a standard
A
To prepare the product for wet drilling
CAUTION:
pressure is not too high. Refer to
data on page 22 .
CAUTION:
water system, use only clean water.
CAUTION:
supply coupling. Speak to your dealer for
more information.
1. Connect the Gardena
valve to the water connector.
2. Open the water system.
3. Set the water pressure to remove all waste material
from the drill hole.
To prepare the product for inverted drilling
WARNING:
with a sealing disc during inverted drilling.
Water that goes into the product increases
the risk of electrical shock.
CAUTION:
dust extractor to collect the slurry.
1. Clean all grease and dirt from the top of the slurry
ring.
Make sure that the water
Technical
To prevent blockage in the
Use only an approved water
®
male coupling with water
Always use a slurry ring
Use a slurry collector or wet
1794 - 001 - 24.03.2022