Clearing All The Remote Control Settings; Direct Function; Confirming Preset Codes - Pioneer VSX-D912K Operating Instructions Manual

Controlling the rest of your system
Clearing all the remote
control settings
You can clear all presets and restore the
factory default settings.
1 Press REMOTE SETUP and hold for
three seconds.
The LCD display shows SETUP.
2 Press any MULTI CONTROL button.
3 Use and to select RESET then
press REMOTE SETUP.
The LCD shows OK when you're done.

Direct function

• Default setting: ON
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the
remote control to set up and listen to a CD on
the receiver and then use the remote control
to rewind a tape in your VCR while you
continue to listen to your CD player.
When direct function is on, any component
you select (using the MULTI CONTROL
buttons ) will be selected by both the receiver
and the remote control. When you turn direct
function off, you can operate the remote
control without affecting the receiver.
1 Press REMOTE SETUP and hold for
three seconds.
The LCD display shows SETUP.
2 Press the MULTI CONTROL button for
the component you want to control.
3 Use and to select DIR SET then
press REMOTE SETUP.
The LCD on the remote displays the compo-
nent you want to control.
4 Use the number buttons to enter
either 9990 (direct on) or 9995 (direct off).
The LCD will display OK to show the four digit
code has been accepted.
• You can't use direct function with the TVC
function.

Confirming preset codes

Use this feature to check which preset code is
assigned to a MULTI CONTROL button.
1 Press REMOTE SETUP and hold for
three seconds.
The LCD display shows SETUP.
2 Press the MULTI CONTROL button of
the component for which you want to
check the preset code.
3 Use and to select READ ID then
press REMOTE SETUP.
The preset code appears in the display for two
seconds.
10
61
En