Dual Mono Setting; Component Video Input Settings; Surround Back Channel Input Setting; Digital Input Settings - Pioneer VSX-D912K Operating Instructions Manual

Setting up the receiver
• Use or to set the dynamic range
control (OFF, MAX, or MID).
• When listening at low volumes, set to
MAX for maximum dynamic range
compression.
• Dynamic range control is effective only
when Dolby Digital and DTS signals are
being played back.

Dual mono setting

Default setting: ch1
•
The dual mono setting can only be used when
listening to Dolby Digital and DTS signals
with dual mono encoding. It is sometimes
used when it is necessary to have one
language on one channel and a different
language on the other. With this setting you
can choose which channel in the dual mono
setting you want to listen to.
If Dolby Digital mode is switched on, you will
hear the channel you have selected (either
ch1 or ch2) through your center speaker. With
Dolby Digital mode off, or if you don't have a
center speaker, you will hear the channel you
have selected through both front speakers. In
the Lch 1.R ch2 setting, the left front speaker
will play channel 1 and the right front speaker
will play channel 2.
• Use or to cycle through the
possible dual mono settings.
Lch 1.R ch2
ch2

Component video input settings

Here you tell the receiver what components
you have hooked up to the component video
jacks on the back of the receiver.
ch1
Component video 1:
• Default settings: DVD
1 Use or to assign the component
video 1 input (DVD, TV, VCR or OFF).
Component video 2:
• Default setting: TV
2 Use or to assign the component
video 2 input (DVD, TV, VCR or OFF).
Surround back channel input
setting
• Default setting: SB 2ch IN
You only have to make this setting if you are
using a seperate component for decoding
DVDs, and the component has only one
surround back channel output. If this is the
case, select SB 1ch IN, otherwise leave it set
to SB 2ch IN.
• Use or to select SB 2ch IN or SB
1ch IN.

Digital input settings

Here you tell the receiver what components
you have hooked up to the coaxial and optical
DIGITAL IN jacks on the back of the receiver.
After you assign a component to a digital jack,
whenever you select that component, (for
example, a DVD player) the receiver
automatically changes to the digital input
setting and DIGITAL shows in the display.
Coaxial digital 1:
• Default settings: DVD
• Use or to assign the coaxial
digital 1 input (DVD, TV, CD, CDR, VCR or
OFF).
07
49
En