Choosing The Input Signal; Listening To Multi-Channel Playback - Pioneer VSX-D912K Operating Instructions Manual

Playing sources

Choosing the input signal

• Default setting: AUTO
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
SIGNAL SEL
RECEIVER CONTROL
• Press SIGNAL SEL (SIGNAL SELECT) to
select the input signal corresponding to
the source component.
Each press cycles through the options as
follows:
AUTO
DIGITAL
ANALOG
The AUTO setting automatically switches to
DIGITAL if a digital source is detected, other-
wise the signal select will be ANALOG.
DVD 7.1ch will only appear when DVD/LD is
selected.
When set to DIGITAL or AUTO, 2 DIGITAL
lights when a Dolby Digital signal is input,
and DTS lights when a DTS signal is input.
• This receiver can only play back Dolby
• You may get digital noise when a LD or CD
• Some DVD players don't output DTS
Listening to multi-channel
playback
DVD 7.1 ch
Digital, PCM (32kHz–96 kHz) and DTS
digital signal formats (including DTS
96kHz/24 bit). With other digital signal
formats, set to ANALOG.
player compatible with DTS is playing an
analog signal. To prevent noise, make the
proper digital connections (page 17) and
set the signal input to DIGITAL.
signals. For more details, refer to the
instruction manual supplied with your
DVD player.
RECEIVER
DVD TV VCR
MULTI CONTROL
RCV CD TUN
STANDARD
INPUT SEL
RECEIVER CONTROL
CD-R
TVC
06
37
En