Table of Contents
Advertisement
20 Plow Assembly
14. Select an area within 16 inches of the vehicle
battery for the motor solenoid. Using the so-
lenoid as a template, mark and drill two 3/16
inch diameter holes then fasten the solenoid
with two 1/4" x 1/2" long self tapping screws
from the hardware bag in the parts box. Con-
nect the Black wire to one of the small posts
on the solenoid, connect the Orange wire to
the remaining small post, polarity is not im-
portant.
15. Safely route the 16-pin circular connector
through the grill of the vehicle to a location
that will be easily accessible with the plow at-
tached.
16. Refer to drawing 6701. Install the underhood
power cable by first connecting the Black
cable and the three Black wires from the har-
ness to the minus (-) post of the vehicle's bat-
tery. Connect the Red (or Red striped) cable
to the motor solenoid. Route the power cable
to the grill near the 16-pin connector.
Connect the red fused wire from the harness
and the 24 inch Red cable to the plus (+) ter-
minal of the battery or battery access post.
Connect the other end of the 24 inch Red
cable to the motor solenoid.
17. Locate three blue connector splices in the
hardware bag in the plow's parts box.
Using a blue splice, crimp the single brown
wire from the underhood harness into the ve-
hicle's driver's side parking light wire.
Using a blue splice, crimp the single yellow
with blue stripe wire from the underhood har-
ness into the vehicle's driver's side turn signal
wire.
Using a blue splice, crimp the single green with
white stripe wire from the underhood harness
into the vehicle's curbside turn signal wire.
DWG NO. 4165
18. Select the proper headlight adapter for your
vehicle, specific instructions are included with
each kit.
The headlight adapter kit consists of two iden-
tical adapters. Install the adapters according
to the instructions included with the kit, then
connect to the 5-pin connectors of the under-
hood wiring harness.
19. Secure all cables away from hot or moving
components with cable ties.
This completes the Electrical Installation.
DWG NO. 6701
Advertisement
Table of Contents
