Hiniker 7812 Operator's Manual page 20

18 Plow Assembly
Truck Battery On Passenger Side
WARNING: Disconnect truck battery
before beginning electrical installation
to avoid shock hazard.
The motor solenoid, underhood wiring harness,
power cable and joystick control box are located
in the parts box shipped with the snowplow frame.
NOTE: To prevent corrosion apply a light coat of
dielectric grease to all electrical connections in-
cluding ring and spade terminals.
8. Refer to drawing 6699. Lay the underhood
harness in it's approximate position for final
assembly with the 7-pin circular connec-
tor near the driver's side firewall. Place the
16-pin connector just left of center near the
grill, the set of four relays near the driver's
side inner fender and the other set near the
passenger side inner fender. Place the 5-pin
headlight connectors at the respective head-
lights.
9. Determine the location of the vehicle bat-
tery. If the battery is located on the right
(passenger) side or if there are two batteries
configured as a 12 volt system, then pro-
ceed to step 10.
If the battery is located on the left (driver)
side of the vehicle, then the wiring harness
will need to be modified.
Refer to drawing 6700. Remove the tape
from the Black corrugated loom at the
points shown. Locate the Orange, Red,
and two Black wires. These wires connect
to the battery and motor solenoid located
next to the battery. Remove the four wires
from approximately 33 inches of the loom,
making sure the Red and Black wires are
long enough to connect to the battery. Tuck
these wires back into the loom as shown in
the drawing and retape the loom.
10. If there is no access hole in the drivers side
firewall then drill a 1-1/8 inch diameter hole.
Route the 7-pin circular connector through
the firewall into the cab compartment and
install the 4 inch grommet in the hole, if re-
quired.
DWG NO. 6699