Specifications; General Power Tool Safety Warnings; Save All Warnings And Instructions For Future Reference - Makita 3612BR Instruction Manual

ENGLISH
1. Stopper pole
2. Fast-feed button
3. Fine adjusting screw
4. Stopper block
5. Lock lever
6. Nylon nut
7. Switch lever
8. Bit
9. Shaft lock
10. Workpiece
11. Bit revolving direction

SPECIFICATIONS

Collet chuck capacity
Plunge capacity
No load speed (min
Overall height
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.... Read instruction manual.
.............. DOUBLE INSULATION
Intended use
The tool is intended for flush trimming and profiling of
wood, plastic and similar materials.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety
Warnings
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Explanation of general view
12. View from the top of the tool
13. Feed direction
14. Straight guide
15. Guide holder
16. Wing bolt (B)
17. Wing bolt (A)
18. More than 15 mm
19. Wood
20. Base plate
21. Screw
22. Templet guide
Model
-1
)
Net weight
Safety class
Save all warnings and
END201-7
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
ENE010-1
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool. Distractions can cause you
ENF002-2
to lose control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
GEA005-3
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet
conditions. Water entering a power tool will increase
the risk of electric shock.
23. Base
24. Templet
25. Distance (X)
26. Outside diameter of the templet
guide
27. Wing bolt (C)
28. Guide roller
29. Vacuum head
30. Limit mark
31. Brush holder cap
32. Screwdriver
3612BR
12 mm or 1/2"
0 - 65 mm
23,000
287 mm
5.5 kg
/II
7