Yamaha xenter HW125 Owner's Manual page 22

INSTRUMENT AND CONTROL FUNCTIONS
below -10 °C, a lower tempera-
ture than -10 °C will not be dis-
played.
● If the ambient temperature climbs
1
above 40 °C, a higher tempera-
ture than 40 °C will not be dis-
played.
2
●
The accuracy of the temperature
reading may be affected when
3
riding slowly (approximately un-
der 20 km/h (12 mi/h)) or when
4
stopped at traffi c signals, railroad
crossings, etc.
5
Clock
To set the clock:
6
1. Push the "SELECT" button and
"RESET" button together for at
7
least two seconds.
2. When the hour digits start flash-
ing, push the "RESET" button to
8
set the hours.
3. Push the "SELECT" button, and
9
the minute digits will start flash-
ing.
4. Push the "RESET" button to set
the minute digits.
5. Push the "SELECT" button and
then release it to start the clock.
Fuel meter
The fuel meter indicates the amount
of fuel in the fuel tank. The display
segments of the fuel meter disappear
towards "E" (Empty) as the fuel level
decreases. When the bottom segment
of the fuel meter and fuel level warn-
ing indicator " " starts fl ashing, refuel
as soon as possible. When the key is
turned to "ON", all of the display seg-
ments of the fuel meter will appear for
a few seconds, and then shows the
actual fuel level.
Brightness control mode
This function allows you to adjust the
brightness of the speedometer panel
to suit the outside lighting conditions.
To set the brightness
1. Turn the key to "OFF".
2. Push and hold the "SELECT" but-
ton.
3. Turn the key to "ON", and then re-
3-6
lease the "SELECT" button after
fi ve seconds.
4. Push the "RESET" button to se-
lect the desired brightness level,
and then turn the key to "OFF".
EAU1044E