Replacing The Computer Cover - Lenovo 10HU Hardware Maintenance Manual

Replacing the computer cover

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
To replace the computer cover, do the following:
1. Remove any media from the drives and turn off all connected devices and the computer. Then,
disconnect all power cords from electrical outlets and disconnect all cables that are connected to the
computer.
2. Remove the slide cover. See "Removing the slide cover" on page 85.
3. Remove the memory module. See "Replacing the memory module" on page 87.
4. Remove the bottom cover. See "Replacing the bottom cover" on page 86.
5. Remove the storage drive. See "Replacing the memory module" on page 87.
6. Remove the Orchid Tilt Stand. See "Replacing the Orchid Tilt Stand" on page 92.
7. Remove the system board shield. See "Replacing the system board shield" on page 97.
8. Remove the cover presence switch. See "Replacing the cover presence switch" on page 98.
9. Remove the VESA mount bracket. See "Replacing the VESA mount bracket" on page 99.
10. Remove the Wi-Fi antennas. See "Replacing the Wi-Fi antennas" on page 96.
11. Remove the Wi-Fi card. See "Replacing the Wi-Fi card" on page 105.
12. Remove the heat sink assembly. See "Replacing the heat sink" on page 106.
13. Remove the system board. See "Replacing the system board" on page 108.
14. Remove the I/O bracket. See "Replacing the I/O bracket" on page 89.
15. Remove the I/O shield. See "Replacing the I/O shield" on page 90.
16. Remove the card reader. See "Replacing the card reader" on page 91.
17. Remove the I/O board. See "Replacing the I/O board" on page 101.
18. Remove the control button board. See "Replacing the control button board" on page 109.
112
ThinkCentre X1 Hardware Maintenance Manual