Exiting The Setup Utility Program; Updating The Bios - Lenovo 10HU Hardware Maintenance Manual

Note: For some keyboards, you might need to press Fn+F12 to display Startup Device Menu.
3. Select the desired storage device and press Enter. The computer will start up from the device you select.
If you want to select a permanent startup device, select Enter Setup on Startup Device Menu and press
Enter to start the Setup Utility program. For more information about how to select a permanent startup
device, see "Changing the startup device sequence permanently" on page 62.

Exiting the Setup Utility program

To exit the Setup Utility program, do one of the following:
• If you want to save the new settings, press the F10 key. Then, select Yes in the window displayed
and press Enter.
Note: For some keyboards, you might need to press Fn+F10 to exit the Setup Utility program.
• If you do not want to save the new settings, select Exit ➙ Discard Changes and Exit and press Enter.
Then, select Yes in the window displayed and press Enter.

Updating the BIOS

When you install a new program, hardware device, or device driver, you might be informed to update
the BIOS. You can update the BIOS from your operating system or a flash update disc (supported only
on some models).
To update the BIOS, do the following:
1. Go to http://www.lenovo.com/drivers.
2. Download the flash BIOS update driver for the operating system version or the ISO image version (used
to create a flash update disc). Then, download the installation instructions for the flash BIOS update
driver you download.
3. Print the installation instructions you download and follow the instructions to update the BIOS.
.
Chapter 6 Advanced configuration
63