Table of Contents
Advertisement
Fluke 192/196/199
Users Manual
Displaying an Unknown Signal with
Connect-and-View™
The Connect-and-View feature lets the test tool display
complex, unknown signals automatically. This function
optimizes the position, range, time base, and triggering
and assures a stable display of virtually any waveform. If
the signal changes, the setup is automatically adjusted to
maintain the best display result. This feature is especially
useful for quickly checking several signals.
To enable the Connect-and-View feature, do the
following:
1
Perform an Auto Set.
the top right of the screen.
The bottom line shows the range, the time base, and the
trigger information.
The waveform identifier (A) is visible on the bottom right
side of the screen, as shown in Figure 7. The input A zero
-
icon (
) at the left side of the screen identifies the ground
level of the waveform.
2
Press a second time to select the
manual range again.
at the top right of the screen.
12
appears at
AUTO
appears
MANUAL
Figure 7. The Screen After an Auto Set
Use the light-gray
,
RANGE
TIME
bottom of the keypad to change the view of the waveform
manually.
and
keys at the
MOVE
Advertisement
Table of Contents
