Hot Tub Flag - Gw & Iw - Fisher & Paykel eco smart PHASE 6 12 Series Service Manual

517766B May 2004
16.9.2 Hot Tub Flag – GW & IW
If the machine has been filled with the hot water valve utilised (ie. warm or hot fill) and has
not had a cold rinse; the electronics will not allow the machine to spin up to its full speed of
1000 RPM. It will only allow the spin speed to reach 700 RPM.
To allow the machine to spin up to 1000 rpm, restart the machine at cold rinse and this will
reset the Tub flag detecting.
GW
The Softener Rinse LED will be on when the Diagnostic Mode is selected if the spin
speed is restricted to 700 rpm. To clear this flag press the Wash Option button below the
Softener Rinse LED.
IW
To remove this flag, enter the Control
Option mode and push the Options Up
button to take the black shading out of the
Hot Tub Flag
box Hot Tub Flag, or put the machine
through a complete final rinse.
NOTE: The drain pump test, water valve test, restart, recycle and hot tub flag features can
be accessed from any level in the diagnostic mode.
- 25 -