Restart Feature - Iw - Fisher & Paykel eco smart PHASE 6 12 Series Service Manual

Electronic washing machine
Table of Contents

Advertisement

517766B
NOTE - This feature is designed as a service aid only and should be left ON in the
customer's home. To return to normal operation, and to reset the RESTART feature to the
factory setting, switch the machine off at the wall or disconnect from the mains supply.
16.8.1
Restart Feature – IW
IW Restart setting can be accessed when in diagnostic mode, pressing the Options button
will bring up the Control Option screen. The LCD screen will display the following:
The machine leaves the factory with the
RESTART set to the ON position (as shown
here), which is indicated in the screen by
the word RESTART highlighted. To turn the
RESTART feature OFF, push the Home
button. This will remove the highlight from
the word RESTART. When the machine is
being serviced, it is more convenient to turn
the RESTART feature OFF. This will allow
any fault in the system to show up
immediately.
With the RESTART feature on:
1.
If a fault occurs in the machine, the diagnostic system will detect it. However,
instead of displaying a fault code immediately, the machine will try to RESTART.
2.
If the fault was only of temporary nature, the machine will restart and finish the
cycle.
3.
If there is a continuous fault the machine will try to RESTART a number of times.
This process could take up to 8 minutes depending on the type of fault. After this, if
the machine still cannot restart, the fault code is displayed and the machine will
beep continuously.
Whether or not the RESTART feature is on is indicated during normal use of the machine
as follows:
1.
If none of the 5 green "HOW DIRTY" LED's are on, the RESTART feature is on.
2.
If the 5 green "HOW DIRTY" LED's are flashing, the RESTART feature is off.
NOTE - This feature is designed as a service aid only and should be left ON in the
customer's home. To return to normal operation, and to reset the RESTART feature to the
factory setting, switch the machine off at the wall or disconnect from the mains supply.
- 23 -
May 2004
Hot Tub Flag

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents