Am-Esp-E002-Xxxx / Am-Esp-E001-Xxxx Models - Delta E Series Installation And Maintenance Instructions Manual
Servo press
Hide thumbs
Also See for E Series:
- Software instructions (25 pages) ,
- Operation and installation manual (73 pages)
Table of Contents
Advertisement
Delta Electronics Servo Press E-Series Installation and Maintenance Instructions
3.1.3
AM-ESP-E002-XXXX / AM-ESP-E001-XXXX models
The fixed servo press is installed with a flange. The fastening ports are shown in the figure below.
Please use 4 general M8X1.25 hex screws (JIS strength 12.9, length 40) and apply the tightening
torque of 334 kgf-cm.
Caution: Please note that the equipment has to be closely attached to the locking and fastening
platform while fastening the servo press.
Suggested digging size
: Locking and fastening site
7
Advertisement
Table of Contents
