If you have any questions relative to a particular application, DO NOT use the machine until you have first contacted Delta to determine if it can or should be performed on the product.
Page 3
ADDITIONAL SAFETY RULES FOR UTILITY SHARPENERS WARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURY. 1. DO NOT OPERATE THIS MACHINE until it is 11. NEVER START THE MACHINE with the workpiece assembled and installed according to the against the grinding wheel.
POWER CONNECTIONS GROUND FAULT CIRCUIT INTERRUPTER (GFCI) PROTECTION SHOULD BE PROVIDED ON THE CIRCUIT(S) OR OUTLET(S) TO BE USED FOR THE UTILITY SHARPENER. A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and should be protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords which have 3-prong grounding type plugs and matching receptacle which will accept the machine’s plug.
Fig. D OPERATING INSTRUCTIONS FOREWORD Delta ShopMaster Model GR050 Utility Sharpener is a valuable addition to any shop. The Utility Sharpener can be used to sharpen most flat cutting tools. UNPACKING AND CLEANING Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from all unpainted surfaces.
Page 7
FILLING UTILITY SHARPENER WITH WATER WARNING: DISCONNECT MACHINE FROM POWER SOURCE. Place the utility sharpener on a flat surface. Loosen the the front tool rest adjusting screw (A) Fig. 3, and move the front tool rest away from the grinding wheel. Pour approximately 3 ounces of water into the front of water trough (B) Fig.
OPERATING CONTROLS AND ADJUSTMENTS STARTING AND STOPPING UTILITY SHARPENER The “Forward / Off / Reverse” switch (A) Fig. 6, is located toward the front of the machine. To turn the machine “ON”, move the switch to the “Forward” or “Reverse” position.
Two Year Limited Warranty Delta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which in normal use has proven to be defective in workmanship or material, provided that the customer returns the product prepaid to a Delta factory service center or authorized service station with proof of purchase of the product within two years and provides Delta with reasonable opportunity to verify the alleged defect by inspection.