Jung FRWM200 Operating Manual page 65

Short acoustic signal,
single device
Short acoustic signal,
single device
Short acoustic signal,
single device
(2) Release testing / stop button.
Shor t acoustic signal, all
d e v i c e s o f t h e s h a r e d
radio group
(3) Perform similar actions for other
radio groups.
5 Successful connection test of the single
device and the shared radio group.
6.8 Restore factory defaults
In the following situations, you must re-
store the factory settings:
Connection attempt was unsuc-
•
cessful and must be repeated
To detach a device from a radio group
•
Operating Manual: FRWM200 - Smoke Alarm Device with Radio Link
EN
Proceed as follows:
(1) Pull out activation button.
(2) Press and hold the testing / stop but-
ton for about 2 to 3 seconds.
(3) Press and hold the radio button with
splint pin until:
(4) Release radio button.
5 The device is in the factory state.
Cancel a device from a radio group
You must cancel a device from a radio
group in the following cases:
Remove device from an
•
existing radio group and
connect it to another group
Remove the defective device
•
from the radio group
65