Storage; Maintenance - Stamina in motion e3000 Owner's Manual

STORAGE

1. To store the InMotion® E3000 simply keep it in a clean dry place.
2. The minimum rest dimensions of the InMotion® E3000 are approximately 28 inches long x 18.5 inches
wide x 49.5 inches tall. These dimensions may vary. Please measure your InMotion® E3000 if exact
dimensions are needed.
3. Grasp the REAR STABILIZER(2) and UPRIGHT(68) to move the InMotion® E3000. Do not use the
PEDAL ARMS(3,4) to move the InMotion® E3000.

MAINTENANCE

The safety and integrity designed into the InMotion® E3000 can only be maintained when the
InMotion® E3000 is regularly examined for damage and wear. Special attention should be given to the
following:
1. Adjust the TENSION KNOB(21) and verify that it functions properly and the resistance changes.
2. Verify that the WARNING LABEL(55) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement WARNING LABEL(55) if it is missing or damaged.
3. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
4. Worn or damaged components shall be replaced immediately or the InMotion® E3000 removed from
service until repair is made.
5. Only Stamina Products supplied components shall be used to maintain/repair the InMotion® E3000.
6. Keep your InMotion® E3000 clean by wiping it off with an absorbent cloth after use.
NOTE: A standard crank extractor tool is required to remove the CRANKS(78) from the AXLE(79).
12