Storage; Maintenance - Stamina 55-1610B Owner's Manual

STORAGE

1. To store the InMotion® E1000 simply keep it in a clean dry place.
2. The InMotion® E1000 is approximately 24.3 inches long x 17 inches wide x 11.4 inches tall. These
dimensions will vary. Please measure your InMotion® E1000 if exact dimensions are needed.
3. Grasp the REAR STABILIZER(2) to move the InMotion® E1000. Do not use the Pedal Arms to move
the InMotion® E1000.

MAINTENANCE

The safety and integrity designed into the InMotion® E1000 can only be maintained when the
InMotion® E1000 is regularly examined for damage and wear. Special attention should be given to the
following:
1. Adjust the TENSION KNOB(21) and verify that the Flywheel System provides tension. The Flywheel
System should provide many years of use.
2. Verify that the WARNING LABEL(55) is in place and easy to read. Call Stamina Products immediately
at 1-800-375-7520 for a replacement WARNING LABEL(55) if it is missing or damaged.
3. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
4. Worn or damaged components shall be replaced immediately or the InMotion® E1000 removed from
service until repair is made.
5. Only Stamina Products supplied components shall be used to maintain/repair the InMotion® E1000.
6. Keep your InMotion® E1000 clean by wiping it off with an absorbent cloth after use.
NOTE: A standard crank extractor tool is required to remove the CRANKS(28) from the AXLE(9).
11