10.2.1 Physical Characteristics
As shown in Figure 41 the ST 700 basic transmitter is packaged in two major assemblies: the
electronics housing and the meter body. The elements in the electronic housing respond to setup
commands and execute the software and protocol for the different pressure measurement types.
Figure 42 shows the assemblies in the electronics housing with available options.
The meter body provides connection to a process system. Several physical interface configurations
are available, as determined by the mounting and mechanical connections, all of which are described
in the Installation section of this manual.
Figure 41 – ST 700 Basic Transmitter - Major Assemblies
Figure 42 – ST 700 Basic transmitter Electronics Housing Components
ST 700 SmartLine Pressure Transmitters User's Manual
Page 120
Revision 13