Fault Conditions And Recommended Corrective Actions - Basic Display; Table 19 - St 700 Standard Transmitter - Fault Conditions And Recommended Corrective Actions For Basic Display - Honeywell SmartLine ST 700 User Manual

8.2.1 Fault Conditions and Recommended Corrective Actions – Basic Display
Table 18 – ST 700 Standard Transmitter - Fault Conditions and
Recommended Corrective Actions for basic Display
Condtion
Fault.
A critical failure has
been detected in
the Meter body
Electronics module
Fault.
A critical failure has
been detected on
the HART, DE, or
FF Electronics
module.
Meter body comm
fault.
Communications
between the meter
body and the
electronics module
has failed.
Revision 13
Analysis
Use a HART, DE, or FF
communicator to read the detailed
status information from the
transmitter. Refer to the appropriate
communicator manual to get more
information about the possible
causes of the failure.
Use a HART, DE, or FF
communicator to read the detailed
status information from the
transmitter. Refer to the appropriate
communicator manual for more
information about the possible failure
causes.
This could be the result of a failure
on either of these modules or the
cable that connects them.
Use a HART, DE, or FF
communicator to read the detailed
status information from the
transmitter. Refer to the appropriate
communicator manual to get more
information about the possible
causes of the failure.
ST 700 SmartLine Pressure Transmitters User's Manual
Recommended Corrective
Action
Cycle power to the transmitter. If
the problem continues to occur,
replace the Meter body.
Cycle power to the transmitter.
If the problem continues to occur
replace the Electronics module.
Check the ribbon cable that
connects the meter body to the
electronics module. Make sure
that the cable is securely plugged
into the electronics module. Make
sure that all pins are plugged into
the connector (e.g., make sure that
the connector is not offset in a way
that leaves some pins
unconnected).
Cycle power to the transmitter.
If the problem continues to occur
replace the electronics module. If
this does not fix the problem,
replace the Meter body.
Page 101