Advertisement
The "R", "G", "B" and "W" buttons are used to set the brightness for the Red,
Green, Blue and White/Amber/UV LEDs, to change the brightness use the "+"
and "-" buttons.
NOTE: See over leaf for DMX address set up examples. DMX Address
Examples:
To set the DMX address "245";
1) Press the "S" button, this means you can now start to set the DMX address.
2) Press the "2" button, so the red LEDs flash, this means the first digit "2"
(the hundreds place) setting is successful.
3) Now Press the "4" button, and the green LEDs flash, this now means that
the second digit "4" (tens place) setting is successful.
4) Now Press the "5" button, and all of the R, G, B, A/W/UV LEDs flash, this
means that the final digit "5" (units place) setting is successful and the full
DMX address setting has been changed
5) Now press the "DMX MODE" button to save the new address into memory.
To set the DMX address "002";
1) Press the "S" button, this means you can now start to set the DMX address.
2) Press the "0" button, so the red LEDs flash, this means the first digit "0"
(the hundreds place) setting is successful.
3) Now Press the "0" button, and the green LEDs flash, this now means that
the second digit "0" (tens place) setting is successful.
4) Now Press the "2" button, and all of the R, G, B, A/W/UV LEDs flash, this
means that the final digit "2" (units place) setting is successful and the full
DMX address setting has been changed.
5) Now press the "DMX MODE" button to save the new address into memory.
Important notes:
• Set the DMX address on each fixture before plugging into the DMX
controller.
• The I.R Remote is not usable when the fixture(s) are being controlled by
a DMX controller.
• The maximum transmitter distance is 10M. Please make sure that you
have the I.R remote aimed directly at each fixture to be programmed,
• If you do not press the "DMX MODE" button after you have changed the
DMX address, when you power down the fixture it will lose the address
you have set.
6. Troubleshooting
Following are a few common problems that may occur during operation
and some suggestions for easy troubleshooting:
A. The unit does not work, no light.
Check the connection of the power and the main fuse.
B. Not responding to DMX controller
1. Check DMX cables to see if linked correctly.
2. If the DMX address is showing but no response to the controller, check the
address settings and DMX polarity.
3. Try another DMX controller.
C. No response to the sound
Make sure the unit is not receiving a DMX signal.
7. Fixture Cleaning
• The cleaning of external optical lenses must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in
which the fixture operates: damp, smoky or particularly dirty surrounding
can cause a greater accumulation of dirt on the unit's optics.
• Clean with a soft cloth using normal glass cleaning fluid or mild soapy
water.
• Always dry the parts carefully.
• Clean the external optics at least every 20 days.
-------------------------------------www.prolight.co.uk------------------------------------------
Advertisement
