TCi F10A Manual page 22

2. Mounting
!
Depending on the version, you can choose between direct mounting or eccentric mounting.
Direct mounting will be done with screws from the back. Use the included in the scope of delivery Wall cut-out and
drilling template.
For Mounting Eccentric loosing screw
A
Now fastening the screw
!
Ludwig-Rinn-Straße 10-14 • D- 35452 Heuchelheim/Giessen • Phone: +49 6 41-9 62 84-0 • Fax: +49 6 41-9 62 84-28 • www.tci.de
Page 22 of 30
Insert the device flush into the cutout. Make sure that the seals are seated correctly, other-
wise the specified protection class cannot be achieved. Now tighten with suitable nuts
evenly and crosswise.
You can recognize the optimal fit by the fact that the seal inserted on the back of the front
is no longer visible from the side. Then no more
continue to tighten, as there is a risk that the permissible max. torque will be exceeded and
damage will occur.
A
and turn out of the „parking hole" in direction of the arrow.
.
Please pay attention:
This system can be used up to a panel thickness of 2.0 mm can be installed.
The maximum torque of 0.6 Nm must also not be exceeded during assembly.
A