TCi F10A Manual page 19

17) An overcurrent protection device with < 4 A must exist outside of the equipment for this device.
The apparent power of the current source must not exceed 250 VA.
18) Never open the device while it is connected to the mains!
19) The operating voltage of the device may only be within the specifi ed ranges.
20) Avoid different
undesirable compensating
Please check the potential differences between 0V of the power supply at the
power input of the system and the chassis after installation and before commissioning!
If any potential differences are detected, it is necessary to install a equipotential bonding bar
or a cable of suffi cient current carrying capacity between the different potentials, i.e. the cable
cross-section of the conductor must be selected such that the expected compensating current
can be absorbed with safety.
21) The device is not suitable for use in nuclear and explosion-endangered areas.
WARNING
!
Do not expose the device to rain or moisture in order to prevent fi re or a short circuit.
If the device is transported in cold weather or is exposed to extreme variations in temperature, make
sure that moisture (condensation) does not form on or inside the device. Prior to operation, the unit
must be allowed to slowly adjust to room temperature. Should condensation occur, a delay time of
approximately 12 hours must be allowed before the unit is switched on.
CAUTION: damage caused by improper handling or mounting is not covered by the manufacturer's
warranty. The PoE function may be affected by different earthing potentials. In this case, PoE may
not be able to be used. PC systems must be shutted down properly before switching off or discon-
necting it from mains to avoid loss of data.Do not display still images for a long time because it may
cause image sticking effects due to the LCD structure and technology. If you want the display to
show a still image, please use a screen saver or the display off function to avoid the image sticking
effect.
pureKNX-Base7 ONLY: This is a class A product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take adequate measures.
Ludwig-Rinn-Straße 10-14 • D- 35452 Heuchelheim/Giessen • Phone: +49 6 41-9 62 84-0 • Fax: +49 6 41-9 62 84-28 • www.tci.de
potentials! Local
currents,
CAUTION: Battery may explode if mistreated. Do not recharge, disas-
semble or dispose of in fi re
This device must not be disposed of in household waste in Europe in
accordance with the WEEE regulations.
Used batteries must not be discarded in household waste. Please
dispose of them at your local collection point for batteries!
potential differences
which can damage
can cause
our systems.
Page 19 of 30