Refrigerant Piping Connections; Installation Overview - LG LS243HLV Installation Manual

Hide thumbs Also See for LS243HLV:
Table of Contents

Advertisement

Installation
Single Zone Wall-Mounted systems are one-to-one
systems. There is a direct piping connection between the
outdoor unit and the indoor unit. The figure at right illus-
trates the basic pipe connections between the outdoor
and indoor unit. Refer to the illustration when proceeding
with pipe connections.
This illustration shows the indoor unit being installed at
a higher position than the outdoor unit. However, if the
outdoor unit be installed at a higher position than the
indoor unit, the basic pipe connections are the same.
Refer back to the tables within the "Connection Limita-
tions" section for specific length limitations in conjunction
with outdoor unit and indoor unit positioning.
• When proceeding with piping connections, adhere to
pipe support spacing lengths as shown in the General
Refrigerant Piping System Information section. Refer
to the "Pipe Supports" section for information on using
clamps and pipe support materials..
• Always adhere to local codes regarding piping and
accurate support spacing along the piping system.
• Always include insulation on all refrigerant and drain
piping to ensure condensate does not form and cause
damage to walls, floors, etc.

REFRIGERANT PIPING CONNECTIONS

Figure 27: Installation and Piping Connection Overview.
Additional field-provided accessories
/ parts / tools that are needed for
installation.
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Air Discharge
Operation Indication Lights /
Signal Receptor
Forced Operation Button
Air Inlet
Air Outlet
Base Plate

Installation Overview

Installation Plate
Sleeve
Bushing-Sleeve
Sealant
Bend the pipe as closely
on the wall as possible,
but be careful not to break it.
Vinyl Tape (Wide)
• Install after drainage test.
• For the drainage test,
pour water into the heat
Saddle
exchanger.
Gas Piping
Liquid Piping
Additional Drain Pipe
Vinyl Tape (Narrow)
Drain Hose
Connecting Cable
31

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ls303hlvLs363hlv

Table of Contents