LG LS243HLV Installation Manual page 20

GENERAL INSTALLATION GUIDELINES
Indoor Unit Mounting
Mounting the Indoor Unit to the Installation Plate
1. Position the indoor unit onto the upper portion of the installation
plate.
2. Engage the hooks at the top of the indoor unit with the upper
edge of the installation plate (number of hooks depends on model
type).
3. Ensure the hooks are properly seated on the installation plate by
shaking the indoor unit left and right.
complete. See next page for steps on how to prepare for piping and
electrical connections.
4. Carefully guide the refrigerant piping and drain piping through the
access hole.
5. Push the bottom of indoor unit towards the installation plate to
anchor to wall.
• Press the lower left and right sides of the unit against the instal-
lation plate until the hooks engage into their slots.
• A clicking sound will be heard as the bottom of the indoor unit
attaches to the installation plate successfully.
• Pay attention to the positioning of the piping through the wall.
The indoor unit can fall from the wall if it is not properly installed and secured to the
• To avoid a gap between the indoor unit and the wall, ensure the screws are
correctly and fully secured to the installation plate.
• To prevent condensate from forming due to an inflow of outdoor air, before indoor
unit installation is finished, completely seal the piping access hole in the wall.
Preparing for Piping / Electrical Connections
1. To prepare indoor unit for piping and electrical installation, disengage bottom on indoor unit from installation plate by reversing Steps 5, 4, and
3 from the previous procedure, if those procedures have been performed.
2. Unsnap the piping / drain hose holder (L-bracket) out from the indoor unit chassis. Prop it open between the indoor unit chassis and
installation plate to separate the bottom of the indoor unit from the wall. This will allow for more working space.
•
• Go to the Electrical Installation section of this manual for information on electrical wiring to the indoor unit.
•
20
-
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 16: Attaching the Indoor Unit to the Installation Plate.
2
Installation Plate
Figure 17: Finishing Indoor Unit Installation to the Wall Plate.
Figure 18: Rear View of the Indoor Unit.
Installation Plate
Drain Hose
Drain Hose Holder /
L-bracket
1
Drain Hose Holder
L-bracket
Installation
Plate