Advertisement
Attention: pressing the + and -buttons intermittently, the numbers will move forward one
at a time. If you keep the buttons pressed they will move faster.
Operating and using the timer .
The programmer can work as a timer.
) and set the time wanted with the + and - buttons; the symbol (
Press 1
(
will light. The time will be memorized after a few seconds and the display will
show the current time. When the time set expires, the symbol (
turns off and the acoustic signal, that lasts about 8/10 minutes, starts. Press any of
the first 4 buttons to stop the signal beforehand. By pressing button 5 (-) the intensity of the
signal, which is composed of three tones, can be changed.
Semiautomatic use of the oven.
There are two ways of using the oven semiautomatically, with which the ignition of the
oven is always manual and the oven can be used for a preset time or until a preset hour.
Starting manual cooking -programmed cooking time
After putting food to cook in the oven, press button 2 (
) and set the cooking time with the + and - buttons; the symbols "Auto" and
will light . Turn the thermostat and selector knobs to the function and temperature
required; cooking will start immediately. When the cooking time is over, the oven and the
control light will turn off, the symbol "Auto" will start flashing and the bell will ring. To
stop the bell beforehand, press button 4 (
); the oven will go to manual. To turn it off turn thermostat and knob to "0".
Starting manual cooking -programmed end of cooking time
After putting food to cook in the oven, press button 3 (
) and set the end of cooking time with the + and - buttons; the symbols "Auto" and
cooking time. Turn the knob of the commutator and thermostat on the function and
temperature required and the oven will start cooking. When cooking time is over, the oven
and the symbol
will turn off, the symbol "Auto" will flash and the bell will ring for about 8/10 minutes.
Press button 4 (
) to stop the bell; the oven will go to manual. To turn it off, turn thermostat and knob
to "0".
Automatic operating of oven: programmed length and end of cooking time.
This is to set the cooking time and end of cooking time; once these two times have been set,
the programmer will set the automatic ignition of the oven. If you make a mistake, press
) and start again.
button 4 (
will light up and stay on until end of
Advertisement
