Table of Contents
Advertisement
Figure 2. Transport Lock-Up Bar - Right Wing
Center Section Lock-Up
1. Raise cutter with hydraulic cylinder to maximum
height.
2. Rotate transport lock into position over cylinder rod
(Figure 3).
Figure 3. Transport Lock In Transport Position
3. Lower cutter against transport lock.
4. To lower cutter for operation, extend hydraulic
cylinder to raise cutter. Rotate transport lock back
away from cylinder rod (Figure 4).
5. Lower cutter to desired cutting height.
16 Operation
DP1
Figure 4. Transport Lock In Operation Position
STORAGE
Follow these steps when storing your cutter:
1. Clean cutter before storing. See page 22 for
cleaning instructions. Store on level, solid ground.
2. Disconnect driveline and secure up off the ground.
3. Lower wings to ground.
4. Raise cutter center section and pin transport bar in
raised position.
5. Attach parking jack and raise tongue weight off
tractor drawbar.
6. Place wedge blocks at front and rear of wheels on
center section and each wing to prevent wheel
rotation.
7. Securely block all four corners of center section
and each wing with jack stands.
8. Remove hydraulic hoses after tractor is turned off
and all system pressure is released by operating
valve levers several times.
9. Remove safety tow chain.
DP2
10. Remove retainer pin and high strength drawbar
pin.
11. Keep children and bystanders away from storage
area.
DP3
MAN1126 (1/9/2015)
Advertisement
Table of Contents
