Installing Upgrades; Order Codes; Duplex Unit - Oki MC560 User Manual

I
NSTALLING UPGRADES
This section explains how to install optional equipment into your MFP. This includes:
> duplex (two-sided printing) unit
> additional RAM memory
> 40GB hard disk drive
> additional paper tray
> storage cabinet
O
RDER CODES
D
UPLEX UNIT
The duplex unit adds the function of two-sided printing, using less paper and making large
documents easier to handle. It also enables booklet printing, which uses even less paper
and makes large documents even easier to handle.
The duplex unit slides straight into the rear of the MFP and requires no tools to install.
1. Unpack the new unit and remove any transit material from it.
2. Switch the MFP off. It is not necessary to disconnect the AC power cable.
3. Ensure that the unit is the right way up, as shown, and push it into the slot behind
the rear panel. The panel will swing inwards as you push the unit into it. Push the
unit all the way in until it stops and latches home.
4. Switch the MFP on and wait for it to warm up (about 1 minute).
5. Print a menu map (refer to
6. Examine the first page of the menu map.
Near the top of the page, between the two horizontal lines, you will see the current
MFP configuration. This list should indicate that the duplex unit is now installed.
All that remains is to adjust the Windows printer driver to make full use of the new
features. See "Adjusting windows printer drivers" on page 99.
OPTION

Duplex unit

RAM memory:
256Mb
512Mb
40GB HDD
Additional paper tray
Storage cabinet
"Information menu" on page
Installing upgrades > 94
ORDER CODE
43347502
01182901
01182902
01184501
43347609
09004619
34).